Many brothers have unstable installation in the dovetail, because the bottom of the dovetail (the arc surface in contact with the dog's body) on the market is very glorious and flat. If we use AB glue to press directly, the gap between the dog body and the dovetail contact surface will be small or no. This will cause the AB glue to run around after pressing, and there will be very little glue on the contact surface. Not yet. So there will be a phenomenon that it will fall off after a short time. To solve this problem, we can do this. Use a drill to drill the bottom of the dovetail scope (the arc surface that is in contact with the dog's body). The large hole in the middle has small holes on both sides. Be careful not to drill through. Then apply glue on the top. The glue should fill the holes, press tightly, and fix them. The purpose of drilling the sight is to increase the area of the glue on the bonding surface to make the bonding stronger.
